Body structure configuration of welding machine assembly prod𒈔uction line

1. The ꦓsupport is made ofဣ 40mm*40mm iron material, working surface height: 750+/-20mm

2. ꦍBoth sides of the wire body are made of 40mm*60mm aluminum profil🃏e.

3. The lamp frame is made 🦋of 40mm*40mm iron material, the lighting is 28W single energy-saving lamp with a cover, and the lamp is made of 20*40 iron flat pass;

4. Power supply system: the power cord adopts standard wires, and the trunking adopts 40*60 galvanized iron wire trough; each station is equipped with a 220V t🧜hree-hole strip socket, 1 per 1 meter.

5. Where there are stations on the line body, use cold plates as countertops, install 1.5-inch galvanized bull's eyes on the countertops, and use galvanized drums for power in other places. (The specific location is shown in the installation diagram)

6. The kanban bracket is made of 25mm*15mm aluminum proꦛfile, and each station has an A4 rubber sleeve.

7. Install 30*28 wind-batch aluminum material and 6-point air pipe on t𝔍he light stand.

8. Instrument panel: 300mm wide, the table top is ma෴de 🅘of δ16mm wood board, the surface is pasted with white fireproof board, and the semi-circular wood edging

9. The tooling board is made of 600*800*16mm wood board with white fireproof board on the bottom, green electrostaꦯtic rubber on the surfacཧe, and green T-shaped edging around.